COMPX RegulatoR - Delete User From Specific Memory Slot (03 - 20)

RegulatoR ® , Keyless Locking 21
Delete User From Specific Memory Slot (03 – 20)
The Supervisor code memory location is called Slot 01 and the first User code
is called Slot 02.
– The additional user codes reside in memory slots 03-20.
– To delete a user code from a specific memory slot (03 -20), follow the
steps on page 9 to enter programming mode.
There is a 10 second programming time limit between each step. If RegulatoR
times out or an error is made, programming will end and you will need to enter
programming mode again.
1. Place RegulatoR into programming mode (see page 9).
2. Press 401 and then press ENTER.
3. Type memory slot to be vacated followed by ENTER (for memory
slots 03 - 09, you must type leading “0” – e.g. “07” for slot 7)
4. Retype memory slot to be vacated followed by ENTER.
5. If successful, the yellow indicator light will illuminate.
Continue programming or press 9 and then ENTER to exit programming.