COMPX RegulatoR User Manual

RegulatoR ® , Keyless Locking 16
Technician Mode – Programming (Manual locking RegulatoR only)
When Technician Mode is ON, the programmed Technician Code can be used to
unlock a locked Single Use Mode RegulatoR without erasing the existing single
use code.
There is a 10 second programming time limit between each step. If RegulatoR
times out or error is made, programming will end and you will need to enter
programming mode again.
1. Place RegulatoR into programming mode (see page 9).
2. To turn Technician Mode ON: type 31 and then press ENTER.
3. Type the desired 4 to 8 digit Technician Code and then press ENTER.
4. Retype Technician Code and then press ENTER
5. REMEMBER THIS CODE
OR
To turn Technician Mode OFF: type 30 and then press ENTER
– If successful, the green indicator light will illuminate for 1
second.
– Press 9 followed by ENTER to exit Programming Mode

COMPX RegulatoR Specifications

General

Brand	COMPX
Model	RegulatoR
Category	Door locks
Language	English