RegulatoR
®
, Keyless Locking 9
RegulatoR Programming Mode
To enter programming mode you must know the supervisor code. The default
supervisor code is 12345. Once in programming mode, multiple changes can be
made prior to exiting programming.
There is a 10 second programming time limit between each step. If RegulatoR
times out or an error is made, programming will end and you will need to enter
programming mode again.
1. Lock must be in the locked position prior to entering programming
mode.
2. Type supervisor code and press ENTER.
Rotate the knob to the unlocked position and press and hold ENTER
for 3 seconds (yellow indicator light will illuminate).
• If product is Self Lock with the SlamCAM feature you can
now let go of the knob.
3. With the yellow indicator light illuminated, programming can begin.
To Next Page
Loading...
Need help?
General