Comrex BRIC-Link - Page 20

20

Generally, it is recommended to congure the Ethernet port of a BRIC-Link for a stac IP. This will facilitate access
to the  with a browser and allow for easier conguraon of routers or rewalls (if necessary).
If the BRIC-Link is to be installed on a managed LAN, Comrex recommends consulng with the IT services provider
about obtaining a stac IP address.
As menoned in the previous secon, the BRIC-Link is congured for by default. This means that it tries to
extract an unused IP address from the network router upon boong. To change the Ethernet IP addressing to ,
select the “” locaon at the boom of the list and change the “” to . The system will prompt a
list of stac sengs as shown in  (on the following page).
As can be seen in the stac IP address, the Netmask, the Gateway Address, and at least one DNS Server
Address must be congured in the proper elds to set a stac IP address. Once that informaon has been inpued,
click the “” buon and select  to have the BRIC-Link accept and acvate the new Ethernet
sengs. Note that if the IP sengs of the Ethernet port have been changed, the connecon to the 
interface will no longer work. Click the “” buon on  to re-sync with the new IP address.