18. When installing or removing attachment, please be sure the unit
is off and no steam is being released to avoid contact with hot
water.
19. Use caution when installing or removing attachment as it may
contain hot water from condensation. Ensure the attachment is
dry or cooled off to avoid contact with hot water.
20. To avoid a circuit overload, do not operate another high wattage
appliance on the same circuit.
21. If an extension cord is necessary, a 10 amp cord should be used.
Cords rated for less amperage may overheat. Care should be
taken to arrange cord so it is not tripped over.
22. Do not iron a garment while it is on person.
23. Do not use continuous steam for more than 10 seconds.
A flooding of the steam chamber may occur, causing hot water
to drip from the soleplate.
24. Iron must be used and rested on a stable surface.
25. When placing the iron on its stand, ensure that the surface on
which the stand is placed is stable.
FILLING INSTRUCTIONS
1. Place the unit on a stable surface.
2. While holding the water reservoir with one hand, move the
release lever toward the power cord.
3. With the reservoir released, pull up on the reservoir to remove it
from the body of the unit.
4. Turn the reservoir over, revealing the rubber inlet cover.
5. Open the inlet cover and fill the tank with everyday tap water
(filtered water may reduce hard water problems).
6. Close the inlet cover and return the reservoir to its place, making
sure that the reservoir is secure
To Next Page
Loading...
Need help?
General
