• Do not use any attachments other than those supplied by Conair
Australia.
• This appliance is not intended for commercial use.
• Do not use if unit has been dropped or damaged.
• Keep the cord away from heated surfaces.
• Never yank the cord to disconnect from the power outlet, instead
grasp plug and pull to disconnect.
• Never operate this appliance if it has a damaged cord or plug, if
it is not working properly, or if it has been dropped or damaged,
or dropped into water. Do not attempt to repair the appliance.
Incorrect reassembly or repair could cause a risk of fire, electric
shock, or injury to persons when the appliance is used. If the
supply cord is damaged, it must be replaced by the manufacturer,
its service agent or similarly qualified persons in order to avoid a
hazard.
• While it is not recommended, if an extension cord is absolutely
necessary, a 15 amp rated power cord should be used. Cords rated
for less amperage may overheat. Care should be taken to arrange
the power cord so that the cord cannot be pulled or tripped over.
• Always ensure that the voltage to be used corresponds to the
voltage marked on the unit.
• For additional protection, the installation of a residual device (RCD)
with a rated operating current not exceeding 30mA is advisable in
the electrical current supplying the bathroom and other parts of
the home. Ask your installer for advice.
To Next Page
Loading...
Need help?
General
