OPERATING INSTRUCTIONS
FILLING THE WATER TANK
(PRIOR TO PLUGGING IN THE APPLIANCE)
Remove the water tank using handle on front of tank.
Fill reservoir using opening on top of tank by holding
it under a source of cold running water until it is filled
to the desired level. Do not overfill. Position the water
tank on the base and make certain it is seated properly
in the unit.
DO NOT FILL THE TANK WITH HOT WATER.
DISTILLED OR FILTERED WATER IS BEST.
Do not unscrew the bottom cap unless for cleaning
(Fig. 4). Note, be sure always empty or fill the tank
over a sink, being careful not to spill water from the
top of the tank.
Only use clean water for filling the steamer. In hard water areas,
we recommend the use of distilled water.
There is no need to fill with warm or hot water, as the steamer
heats the water while producing steam.
NB - NEVER USE ADDITIVES SUCH AS SALT, PERFUME OR DYE WITH
THIS STEAMER. THESE SUBSTANCES WILL CORRODE OR CLOG THE
INTERNAL PARTS OF THE STEAMER.
(Fig. 4)
To Next Page
Loading...
Need help?
General
