How to Use Your Conbrov T11 Camera
1.Turning the Camera On/Off
(1) Press and hold the to switch the camera on.
The LED will light up blue, which indicates that
it is in standby mode.
(2) Press and hold the to switch the camera off.
The LED will flash alternating red and blue and
then turn off.
ON lights up blue
and the camera is
in standby mode
OFF flashes alternating
red and blue and then
turns off
Note: If the camera switches off automatically,
there are two reasons:
1. The battery power is too low and the camera
must be charged.
2. The camera has been in standby mode without
any operation for longer than 1 minute. In this
case, the camera switches off to save battery
power.
2. How to Record a Video
1)Continuous Manual Recording(Press after the
Camera is powered on)
Press the LED will flash blue for 3 seconds
and then goes off, A 10-minute video clip will
be recorded .
12
2S
To Next Page
Loading...
