13
INSTRUCTOR’S MANUAL
RECOMMENDED MAINTENANCE SCHEDULE:
On a Regular Basis
• Untwist the cords if they appear to be twisted
• Clean grips
Every 500,000 Meters (approximately 50 hours of use)
• Inspect the cords
• Inspect the fasteners
• Inspect the top bracket pulleys
As Needed
• Clean all surfaces including floor stand
• Vacuum flywheel enclosure
IMPORTANT SAFETY NOTES
The safety level of the machine can be maintained only if it is examined regularly for damage and wear.
Replace defective components immediately to ensure safety and performance or keep machine out of use
until repaired.
• Use of this machine with worn or weakened parts (pulleys, cords, spools) may result in injury to the
user. When in doubt about the condition of any part, Concept2 strongly advises that it be replaced
immediately. Use only genuine Concept2 parts. Use of other parts may result in injury or poor
performance of your machine.
• The SkiErg with optional floor stand must be used on a stable, level surface.
• The wall-mounted SkiErg must be securely fixed to the wall at the top and bottom brackets. Be sure
that your mounting bolts are going into a solid material such as wood or concrete, and that you are
using the proper hardware for the wall material.
• Do not twist or cross cords, and avoid pulling cords all the way out to the point at which they stop.
• Do not release handles when they are in the pulled out position. Bring handles back to the top
position before releasing them.
• Perform regular inspection and maintenance as recommended.
• Keep unsupervised children away from the SkiErg.
Other Safety Tips:
• Do not rely on handle cords to hold you up.
• Do not let go of the handles.
• Do not pull the handles to the ends of the handle cord length.
• Perform proper maintenance as described above.
To Next Page
Loading...
