ENGLISH
to complete the installation.
6 After installing TCP/IP, go back to the Network dialog box. Select TCP/IP from the list
or Network Components and then click the Properties button.
7 Check each of the tabs and verify the following settings:
Bindings: Check Client for Microsoft Networks and File and printer sharing for
Microsoft Networks.
Gateway: All fields are blank.
DNS Configuration: Select Disable DNS.
WINS Configuration: Select Disable WINS Resolution.
IP Address: Select Specify an IP Address. Specify the IP Address and Subnet
Mask as following example.
3 IP Address: 10.0.0.3 (any IP address within 10.0.0.2~10.0.0.254 is
available, do not setup 10.0.0.1)
4 Subnet Mask: 255.0.0.0
8 Reboot the PC. Your PC will now have the IP Address you specified.
1b) Windows 2000
1 Click the Start button and select Settings, then click Control Panel. The Control
Panel window will appear.
2 Double-click Network and Dial-up Connections icon. In the Network and Dial-up
Connection window, double-click Local Area Connection icon. The Local Area
Connection window will appear.
3 In the Local Area Connection window, click the Properties button.
4 Check your list of Network Components. You should see Internet Protocol [TCP/IP]
on your list. Select it and click the Properties button.
5 In the Internet Protocol (TCP/IP) Properties window, select Use the following IP
address and specify the IP Address and Subnet mask as following.
• IP Address: 10.0.0.3 (any IP address within 10.0.0.2~10.0.0.254 is available,
do not setup 10.0.0.1)
• Subnet Mask: 255.0.0.0
6 Click OK to confirm the setting. Your PC will now have the IP Address you
specified.
To Next Page
Loading...
