ENGLISH
Point. This Access Point supports 64/128-bit
WEP Encryption function. With this function,
your data will be transmitted over the wireless
network securely.
# You can refer to the detail setting from
chapter 3.2.6.
Advance setting It provides more powerful features for you to
configuring.
# You can refer to the detail setting from
chapter 3.2.8.
Click Apply button at the bottom of the screen to save the above configurations. You can now
configure other advance sections or start using the Access Point.
3.2.10 PMP Mode Configuration
This function provides to bridge more than 2 wired Ethernet networks together by wireless
LAN. You can use two access points with “P2P mode” to bridge two wired Ethernet networks
together.
Parameter Description
AP MAC Address If you want to bridge more than one wired
Ethernet networks together with wireless LAN,
you have to enter the MAC addresses of other
access points that join the bridging work.
Mode 802.11b mode: It allows to select the transmit
rate up to 11Mbps 802.11g mode: It allows to
select the transmit rate up to 54Mbps
Mixed mode: It provides best performance for
11g transmission when you enable the AP
To Next Page
Loading...
