ENGLISH
Infrastructure: It can let your network device
join a wireless LAN through an access point.
Channel Select the appropriate channel from the list
provided to correspond with your network
settings. Channels differ from country to
country.
Channel 1-11 (North America)
Channel 1-14 (Japan)
Channel 1-13 (Europe)
There are 14 channels available.
Security Disable: Disable the security function.
WEP: WEP is an authentication algorithm,
which protects authorized Wireless
LAN users against eavesdropping. The
Authentication type and WEP key of wireless
stations must be the same with the Access
Point. This Access Point supports 64/128-bit
WEP Encryption function. With this function,
your data will be transmitted over the wireless
network securely.
# You can refer to the detail setting from
chapter 3.2.6.
WPA: You can use a pre-shared key to
authenticate wireless stations and encrypt data
during communication. When you enabled
WPA mode, you can not use WEP encryption.
# You can refer to the detail setting from
chapter 3.2.7.
Preamble Type Preamble type defines the length of preamble
block in the frames during the wireless
communication.
Auto select: It will auto switch to the more
suitable method.
Short: It is suitable for high traffic wireless
network
Long: It can provide more reliable
communication
Transmit Rate When you enable the station mode selection to
“802.11b” and it allows you to select the speed
of 1-11Mbps. When you enable the station
mode selection to “802.11g” and it allows you
to select the speed of 1-54Mbps.
Click Apply button at the bottom of the screen to save the above configurations. You can now
configure other advance sections or start using the Access Point.
To Next Page
Loading...
