Conceptronic cm3pvrd - Page 4

Copyright
®
2009 by Conceptronic – All rights reserved
www.conceptronic.net
Page 4 of 4
Scheduled recording
1. Press button ‘6’ on the remote control of the CM3PVRD or select the ‘Rec. Schedule’ icon from
the CM3PVRD menu. The CM3PVRD will enter the recording schedule page and automatically
select an empty recording slot.
2. Press the ‘ENTER’ button on the remote control of the CM3PVRD and use the ‘UP’ and ‘DOWN’
buttons to select ‘AV’ as input. Press the ‘ENTER’ button again to go to the next option.
3. Select the recording date with the ‘UP’ and ‘DOWN’ buttons and use the ‘ENTER’ button to
confirm.
4. Select the start time and use the ‘ENTER’ button to confirm.
5. Select the end time and use the ‘ENTER’ button to confirm.
6. Select the target and quality for the recording and use the ‘ENTER’ button to confirm.
Note: When using a USB stick or memory card, please make sure there is enough space available for the
recording. If there is not enough space available, you can change the quality of the recording to
reduce space. Refer to the last pages of the CM3PVRD manual (“Product Specifications”) for a
list of required space with each quality.
7. When all settings are correct, the ‘STATUS’ field at the left of the screen will mention ‘READY’.
8. Now press the ‘MENU’ button to return to the main menu and press the power button on the
remote control of the CM3PVRD to set it in stand-by mode.
Note: Do not use the switch on the back of the CM3PVRD to turn off the device, since it will not be able
to turn on itself when a recording needs to be started. The device always needs to be in stand-by
mode when a recording is scheduled.
9. Make sure the TVDVB-T is set to the right channel for the recording and leave it turned on.