Copyright
®
2008 by Conceptronic – All rights reserved
www.conceptronic.net
Page 2 of 7
B. WARNING !!!
There are two different versions of the Conceptronic Media Player on the market. Both versions only
differ in hard disk connection type (SATA vs. IDE) and the supplied remote control. Since the devices are
so similar it is mandatory to pick out the right product when upgrading the firmware. The easiest way to
identify your Media Player is through the remote control.
Below you see an image of both remote controls, continue this firmware upgrade procedure only when
you have the MIDDLE or RIGHT remote control (CSM3PL rev. 1 or CSM3PL rev. 2).
To Next Page
Loading...
