To Next PageTo Next PageWhy is gas escaping from Concoa INTELLISWITCH Switch regulator block?
If gas is escaping from the side of the regulator block in your Concoa Switch, it's likely due to a failed burst disk. Replace the burst disk to stop the leak.
Details the IntelliSwitch as a device to monitor, control, and switch gas flow.
Highlights primary features like multiple gas sources, Look Back, and Switchback Delay.
Covers Hysteresis, Economizer Function, and Settable Switchover Pressure.
Includes Manual Bank Switching, Units of Measure, and Security Lockout.
Details Serial Port functionality, Alarm Notification, and Burst Disk Protection.
Front panel buttons allow selection of liquid or high pressure cylinders.
Details the three liquid cylinder pressure ratings supported by the IntelliSwitch.
Manual bank switching and reset button functions for alarms.
Entering and using the diagnostic test mode for troubleshooting.
Procedure for changing the switchover pressure via DIP switches.
How to change display units to PSI, BAR, or MPA using DIP switches.
Enabling/disabling front panel button lockout using DIP switch SW3-4.
Controlling serial communication via DIP switch SW3-1.
Details wiring and cable assembly for connecting CONCOA Remote Alarms.
Information on connecting the IntelliSwitch to external serial devices like PCs.
Covers display, date, software revision, transducer, valve, and alarm tests.
Tests for buttons, delays, hysteresis, and calibration values.
General