Retro Fit Barrier Kit
Barrier Kit for Ladder Models #6000, #6100, #7000 and #7100
3. Place the Base and Brace into position, centered, on the bottom and fourth treads of the ladder.
Install the 4 #10 x 1-14 screws on a slight angle as shown, first in the Upper Brace, and then in the
Lower Base.
4. Install the self-adhering foam strips to the Large
Barrier Section as shown. Finally, install the Ladder
in the Swimming Pool according to the Instructions provided
with the Ladder.
Note: Barrier sections must be filled with water to prevent
floating.
CONFER PLASTICS, INC.
97 WITMER ROAD
NORTH TONAWANDA, N.Y. 14120-2421
www.conferladders.com
PRINTED IN USA
To Previous Page
Loading...
