Step 1.
Snap stringers
into bottom tread.
If necessary lift
the two stringers
off the ground,
with the bottom
tread attached,
and drop them
firmly so that the
stringers “snap”
into the tread
pockets. The
bottom tread
should pivot
freely.
Make sure the
single row of
tread lugs are
facing forward.
Tread Lugs
Step 2.
Two sets of Lug
locations are provided.
Attach 4 upper treads
to the stringers in the
position determined by
the pool height.
Tread Lugs
Step 3.
Step 4.
Using a pair of pliers twist off
the wedges that are attached
from the end of the platform
and SAVE for use in step 5.
Wedges
Protrusion
Detach
Wedges
Use upper
lugs for
50" to 54" pools.
Use lower
lugs for
42" to 48" pools.
Secure the
upper treads
by driving
#10 x 1-1/4"
screws through
the recessed,
pre-drilled holes
in the ends of
each tread as
shown. Repeat
for all 4 upper
treads.
Step 5.
Assemble the platform to
the handrails by laying
one of the handrails on a
clean hard surface. Push
the protrusion of the plat-
form into the openings of
the handrail making sure
that the legs of both
handrails are facing in the
same direction. Tap the
4 wedges (from step 4)
into the sides of the
handrails to secure the
platform to the rails.
Step 6.
If needed, coat tubes
with liquid soap or
lubricant and slip the
adjustable tubes
through the mounting
blocks all the way
down over the
protruding nubs.
Mounting Block
Adjustable tube
Slide mounting
blocks over nubs
Step 7.
Step 8.
Stringers
Step 9.
Attach the handrails to
the ladder assembly,
making certain that the
treads face correctly.
Match
Platform
protrusions
to Handrail
openings
After platform is in
position, tap in the
supplied wedges at
the bottom of each
opening to ensure a
secure fit
Push the
adjustable tubes
with mounting
blocks into
handrails.
Fill both stringers with water to
allow the ladder to be submerged
in the pool.
Push
down
2
Hardware Pack
26- #10 x 1-1/4" screws
2 - Mounting Blocks
2 - Adjustable Tubes
Tools Needed for Assembly
* - Cordless Drill Motor
* - 1/8" Drill Bit
* - Phillips Screwdriver
or screwdriver bits
* - Pliers
* - Garden Hose
* - Liquid soap or lubricant
Barrier Parts List
(Included in Hardware Pack)
4 - #10 x 1-1/4” screws
1 - Strip of 4 Foam Pads
1 - Large Barrier Section
1 - Small Barrier Section
1 - Upper Brace
1 - Lower Base
Model #6000X Adjustable Heavy-Duty Inpool Ladder
ASSEMBLY INSTRUCTIONS - PLEASE READ BEFORE ATTEMPTING ASSEMBLY
Parts List
2 - Handrails
2 - Stringers (Legs)
4 - Upper treads
1 - Bottom tread
1 - Platform with Wedges
(See Step 4)
If missing parts call - Toll free U.S. - 866-396-2968 or www.conferladders.com
WEDGE
HANDRAIL
PLATFORM
ADJUSTABLE
TUBE
UPPER
TREAD
MOUNTING
BLOCK
STRINGER/
LEG
BARRIER
SECTION
BOTTOM
TREAD
To Next Page
