Need help?Do you have a question about the Consew 223 and is the answer not in the manual?
General| Stitch Type | Lockstitch |
|---|---|
| Max Stitch Length | 5 mm |
| Needle Type | DB x 1 |
| Motor Type | Clutch |
| Motor | 1/2 HP |
| Type | Industrial |
Guide to assembling and setting up the sewing machine on the table with its components.
Details on maximum operating speed and recommended break-in speed for durability.
Instructions on where and how often to oil the machine for optimal performance and longevity.
Guidance on choosing the correct needle size and proper method for inserting it into the needle bar.
Information on suitable thread materials and the importance of using left-twist thread for the needle.
Step-by-step instructions for inserting and removing bobbins from the bobbin case.
Procedure for winding thread onto the bobbin using the bobbin winder mechanism, including tension settings.
Detailed guide for threading the sewing machine through its various guides, levers, and tension discs.
Methods for adjusting upper and lower thread tensions to achieve balanced and perfect stitching.
How to adjust the pressure applied by the presser feet to the material for proper feeding.
Techniques for setting the stitch length using machine controls and reference charts for stitch per inch.
Adjusting the vertical movement of the alternating presser feet for adequate material clearance.
Instructions on how to reset the safety clutch mechanism when it disengages due to jamming.
Detailed steps for removing and installing the timing belt on the sewing machine's pulleys.
Procedure for setting the correct height of the feed dog relative to the needle plate surface.
Ensuring precise timing alignment between the needle, feeder, and needle plate for correct stitch formation.
Adjusting the vertical position of the needle bar relative to the needle eye and hook for optimal sewing.
Setting the correct timing relationship between the hook and the needle for stitch formation.
Setting the correct clearance for the bobbin case opener relative to its holder for smooth operation.
Adjusting the height of the presser bar lifter and the lifting presser foot for material feeding.
Timing the vibrating presser foot to correctly hold goods during needle passage, preventing irregular stitches.
Adjusting the thread controller spring tension for proper management of thread slack and delivery.
Guide to passing tape through the binder and its associated guides for edge finishing.
Methods for positioning the binder based on material characteristics and tape width for optimal results.
Setting the proper clearance between the feed dog and the binder unit for smooth tape feeding.
Adjusting the binder's movement to synchronize or desynchronize with the feed motion for specific applications.
To Next Page
