To Next PageTo Next Page
Need help?Do you have a question about the Consew 206RBL and is the answer not in the manual?
General| Stitch Type | Lock Stitch |
|---|---|
| Needle System | DBx1 |
| Max Stitch Length | 5 mm |
| Reverse | Yes |
| Presser Foot Lift | Manual |
| Feed Mechanism | Walking Foot |
| Motor Type | Clutch |
| Machine Weight | 35kg |
| Type | Industrial Sewing Machine |
Attaches rubber hinge and corner rubber to the sewing machine table for stability.
Secures the oil pan to the designated opening on the sewing machine table.
Mounts the main sewing machine head onto the table using hinge connections and corner rubbers.
Inserts and tightens the spool pin into its designated installation hole on the machine.
Assembles and installs the knee lifter mechanism for operating the presser foot.
Attaches and tensions the drive belt between the motor pulley and machine pulley.
Mounts the left belt guard to protect moving parts and ensure safety during operation.
Assembles and secures the thread stand to the work table for thread management.
Details the procedure for lubricating the sewing machine parts to ensure smooth operation and longevity.
Verifies that the machine pulley rotates in the correct direction as indicated by the arrow.
Guides the process of inserting and securing the sewing needle into the needle bar.
Explains how to safely open the bed slide and remove the bobbin case from the machine.
Details the steps for winding thread onto the bobbin using the bobbin winder.
Describes the correct method for inserting the wound bobbin and bobbin case into the rotary hook.
Provides instructions on how to thread the upper thread through the sewing machine's guides and tension discs.
Explains how to set the desired stitch length using the feed regulating dial.
Outlines the basic steps to begin sewing with the machine after preparation.
Explains how to reverse the stitch direction for reinforcing seams using the reverse lever.
Details how to adjust upper and lower thread tensions for optimal stitch quality.
Guides the adjustment of presser foot pressure to ensure proper material handling.
Describes how to adjust the operating range and tension of the thread controller spring.
Explains how to set the maximum height of the feed dog relative to the needle plate.
Guides the adjustment of the feed dog's longitudinal position for stitch control.
Ensures the needle correctly enters the center of the feed dog's needle hole.
Sets the correct timing relationship between the needle's downward movement and the feed dog's movement.
Adjusts the needle bar height to achieve the correct measurement from the needle plate to the needle eye.
Aligns the hook point with the needle center and sets the clearance for proper thread capture.
Sets the clearance for the opener and hook to facilitate smooth thread loop passage.
Adjusts the clearance to prevent irregular stitch length or overheating.
Sets the standard height for the lifting presser foot after it has been raised.
Adjusts the vertical movement amount of the vibrating and lifting presser feet.
Ensures the vibrating presser foot correctly engages and holds material during sewing.
Adjusts the feed regulator to ensure equal stitch length for forward and reverse feed.
Describes how to release the safety clutch mechanism if the thread becomes entangled.
