5. PREPARATION BEFORE SEWING
5-5. Threading the upper thread
. A CAUTION
A • Turn off the power switch before threading the upper thread. The motor will keep turning evenLb after the power is switched off as a result of the motor's inertia. Wait until the motor stops fully
before starting work. The machine may operate if the treadle is pressed by mistake, which could
result in injury.
Turn the machine pulley and raise the thread take up
lever. before threading the upper thread. This will
make threading easier and it will prevent the thread
from coming out at the sewing start.
5-6. Adjusting the stitch length
, ,
Stitch length can be set by turning the feed regulat-
ing dial
O.
Numeric figures on the dial 0show the stitch length
in mm. The desired numeric figure on the dial
0
should be set at just above, while depressing the
revers lever. slightly.
- 11 -
To Next Page
Loading...
