Consew 206RBL - Sewing Preparation Steps; Install Sewing Needle; Remove Bobbin Case

5. PREPARATION BEFORE SEWING
5. PREPARATION BEFORE SEWING
5-1. Installing the needle
A CAUTION
A • Turn off the power switch before installing the needle. The motor will keep turning even after the~ power is switched off as a result of the motor's inertia. Wait until the motor stops fully before
starting work. The machine may operate if the treadle is pressed by mistake, which could result in
injury.
Long groove
1. Turn the machine pulley toward you to move the
needle bar to its highest position.
2. Loosen the screw
O.
3. Holding the needle. with its long groove facing
left, insert all the way into the needle bar.
4. Tighten the screw
O.
5-2. Removing the bobbin case
I A CAUTION
A • Turn off the power supply before removing the bobbin case. The motor will keep turning even afterl.:!!::1 the power is switched off as a result of the motor's inertia. Wait until the motor stops fully before
starting work. The machine may operate if the treadle is pressed by mistake, which could result in
injury.
1. Open the bed slide.
2. Pull the latch
0 of the bobbin case upward and
then remove the bobbin case.
3. The bobbin. will come out when the latch
0is
released.
- 9 -