Consort C931 - Technical Assistance Form - Conductivity

C931 • C932 • C933 43 / 47
Perform the following steps:
16. reset the meter (switch on while holding MODE pressed). yes?
15. store all conductivity cells in distilled water with some detergent overnight. yes?
18. connect a 1000 ohm resistance to the conductivity input and read display. µS:
19. select the °C mode, measure temperature of solutions and read the display. °C:
20. rinse the conductivity cell with a 0.01 M KCl calibration solution (1413 µS). yes?
17. leave the EC input open, select the conductivity mode and read display. µS:
21. connect the conductivity cell, dip in fresh cal. solution (stir!) and read display. µS:
14. type of connected electrode:
22. rinse a new conductivity cell with a 0.01 M KCl calibration solution (1413 µS). yes?
23. connect this conductivity cell, dip in fresh cal. solution (stir!) and read display. µS:
Technical assistance form - Conductivity
If you need assistance with a technical problem, make sure to fill the complete
checklist (all 23 points!) and fax a copy to Consort: +32/14/429179.
1. purchase date:
5. organisation:
7. division:
6. name:
8. address:
9. postal code: 10. city:
11. telephone:
12. telefax:
13. e-mail:
2. indicate model:
4. serial no:
C931 - C932 - C933
2. purchased from:
"