C931 • C932 • C933 5 / 47
Introduction
This instrument is manufactured with the latest technology and needs no particu-
lar maintenance. CONSORT certifies that this instrument was thoroughly inspect-
ed and tested at the factory prior to shipment and found to meet all requirements
defined by contract under which it is furnished. However, dimensions and other
physical characteristics may differ.
The normal operating temperature should be between 4° and 40°C. Never store
the instrument in a room with high humidity or at very low temperatures (con-
densation water!).
Manufacturer
CONSORT nv
Parklaan 36 Tel (+32)(14)41 12 79
B2300 Turnhout Fax (+32)(14)42 91 79
Belgium E-mail: info@consort.be
Warranty
This instrument (excluding all accessories) is warranted against defective material
and workmanship for a period of thirty-six (36) months from the date of shipment
ex factory. CONSORT will repair all defective equipment returned to it during the
warranty period without charge, provided the equipment has been used under
normal laboratory conditions and in accordance with the operating limitations
and maintenance procedures in this instruction manual and when not having been
subject to accident, alteration, misuse or abuse. A return authorisation must be
obtained from CONSORT before returning any product for warranty repair on a
freight prepaid basis!
CONSORT is not liable for consequential damages arising out of the use or handling
of its products.
Servicing
In the event of this instrument being returned for servicing, the owner is request-
ed to remove the power supply lead and NOT to send the following items unless
they are suspect:
Manual
Cables
Accessories
If serious malfunctioning occurs, stop using the unit immediately and consult your
local CONSORT dealer.
Batteries
The batteries can be replaced by opening the bottom compartment of the cabinet.
Only use NiMH batteries!
AC adaptor
Remove the protective silicone stopper from the DC socket and connect the jack
of a suitable AC adaptor (model A4070 for 230 V~ or model A4071 for 115 V~)
to the DC socket for recharging the NiMH batteries. Avoid to use an AC adaptor
without NiMH batteries being inserted in the instrument! For field work, remove
the adaptor and re-insert the protective silicone stopper into the DC socket. Do
not hold the adaptor by wet hand!
To Next Page
Loading...
