Consort EV245 - Method Programming Details; Timer and Progression; Starting and Interruption

8
Enter the desired power limit
and press SET:
This limit is automatically set to its
maximum and cannot be changed in
case of a Voltage gradient step.
Enter the desired timer unit (h or kVh)
and press SET :
h
The timer will count in hours and
minutes.
kVh
The timer will run in kiloVolthours.
Enter the desired timer value
and press SET :
The value format is hh:mm when
entering a value in hours (h), a value
with 2 decimal places when entering
kiloVolthours (kVh).
Decide if the experiment should
automatically proceed with a next step,
press SET :
Choose NO to resume at point 6 to
proceed with the next step, choose
YES to stop after this step.
Press RUN/STOP to start the experiment.
• At any time, you can return to the main menu by holding SET pressed.
• At any time, you can avoid programming unnecessary parameters. To do so, simply press
RUN/STOP instead of SET after entering the last relevant value and the instrument will immediately
start the experiment keeping the other parameters to their previous values.
• To ensure that the desired parameter is kept constant, we suggest to pre-set all other parameters
to its maximum.
• The behaviour of the power supply during a procedure is described in the chapter Running Condition.
METHOD 1|1
POWER
150
W
METHOD 1|1
TIMER UNIT
h
METHOD 1|1
TIMER
00:30
h
METHOD 1|1
END METHOD
NO