8
✔ The side of flame should be of a
light violet color.
✔ A yellow flame indicates a lack of
oxygen, probably because the flame
is too high.
Testing the Safety Device
Your Refrigerator is equipped with a
safety device that interrupts the flow
of gas in the event that the flame goes
out. To test its operation, extinguish
the flame leaving the gas to continue
to flow, as in the following
instructions:
✔ Leave the
Refrigerator
operating with
the flame turned
up, the
thermostad in
coldest position.
The operation of an absorption
Refrigerator is completely silent and
thus one cannot hear if it is working
or not.
Even so, the inside of the Freezer
will become cold after an hour of
operating.
Within 6 to 12 hours, depending on
the room temperature, the
Refrigerator will attain its operating
temperature.
We suggest that you leave the
Refrigerator working without loading
it with food for several hours.
✔ Shut and then
open the selector
valve button.
✔ The flame will go
out but the supply
of gas will
continue. (If you
have any doubts,
ignite the gas, and
you will see the
flame appear.
Wait a few
minutes and repeat
the preceding
operation).
✔ With the flame put out and the gas
turned on, wait 30 to 40 seconds
and the valve will shut off, making
a low but distinctive “clicking”
sound.
✔ Using the ignition button check that
the flame will no longer ignite,
indicating that the safety device is
working and has shut off the gas
supply.
3
Operation
LOADING YOUR REFRIGERATOR
✔ Even with the Refrigerator working,
avoid loading it all at once with a
large amount of food.
✔ We recommend that food be stored
in adequate packages such as
plastic bags or containers with lids.
It avoids the removal of food natural
humidity, preserving quality.
ENGLISH
Gas Temperature Control
To Next Page
Loading...