Contax Aria - Attaching the Eyepiece Cover and Strap

@ Exposure Compensation Mark
When the exposure compensation dial is set
anywhere other than to “0”, the “+” or “-” mark
will blink (see page 126).
@ Exposure Warning Mark “a” "e"
In the auto exposure mode (“Av”, “Tv”, or “P”),
the over “A” or under ^w" mark indicating
deviation from the exposure control range will
blink.
® Exposure Meter
This meter indicates the following depending
on exposure mode.
(DAuto exposure modes (“Tv”, “Av”, "P"
modes)
Only displayed during evaluative metering
when it shows how it differs from the center-
weighted average light metering (see page
108).
@Manual exposure “M” or flash exposure “X”
Displays the difference between set
exposure value and correct exposure (in
selected exposure mode) (see page 112).
®Bulb exposure
Not displayed
Exposure Counter
The exposure counter shows the number of
frames in position for exposure (a number
between 00 to 39 or E for any number of 40
and above). It also provides the following
functions:
e Displays the remaining time while the self-
timer is operating (10 sec. to 00)
€ Displays the operation order in the "A.B.C."
mode (automatic exposure compensation
for three consecutive frames).
e Displays the end of the film.
43