Contax T3 - Key Controls Overview

(t-Nsase button:
The Main Switch/Aperture Dial is
used to turn the camera ON/OFF,
and for setting the aperture value
when using the aperture-priority
automatic exposure mode.
When the main switch is turned
from “ © ” to “P”, the camera is
turned ON and ready for use in the
programmed automatic exposure
mode (p. 23, 35). By holding the
dial lock-release button depressed
and turning the dial to one of the
aperture values in the range “2.8-
16,” the camera will be set for
aperture-priority automatic
exposure (p. 36).
Example display during
aitomatio flash mode.
The flash mode button is used to
select the flash mode.
After the camera is switched ON,
each time you press the flash mode
button the flash mode is changed
in the order shown below; the
corresponding mode is indicated
on the display (p. 26).
© Automatic Flash mode ''u ™ ”
® Red-eye-reduction Flash mode
M L AUTO >1
> «®>
@ No-flash mode ”
® Fill-in Flash mode “ ^ ”
® Night Portrait Flash Mode
• The default flash mode (the mode
set automatically when the camera is
turned on) can be changed if desired
P-