Contax T3 - Page 15

V’*. ' .r'*. I «
O Pull out the film leader
from the cartridge until
it reaches the orange
colored “ “• ” (film leader
mark), and lay the film
leader on top of the take-
up spool.
When pulling out the film
leader, do not puli out too much
so that the film buckles.
• If you accidentally pull out too
much film, adjust the length
before continuing.
A Close the camera back
securely.
When the camera back is
closed, the film automatically
advances to the first frame and
stops with the expos,jre
counter at “01”.
If the exposure counter displays
a blinking “00", the film is not
advancing properly; the shutter
will not operate in this
condition. Open the camera
back and load the film correctly.
19