Contax T3 - Page 16

When the final frame of a
roll has been exposed, the
camera automatically
rewinds the film into the
cartridge.
During rewinding, the exposure
counter displays decreasing
numbers until rewind is
complete, at which point the
motor stops and the exposure
counter shows a blinking “00”.
When rewind is compiete, open
the camera back and remove
the film cartridge.
Never attempt to open the
camera back until rewinding is
complete.
• After film is rewound, the camera will not operate again until the camera
back is opened.
• To manually rewind film mid-way through a roil, use the tip of the
adjuster on the accessory strap (or other pointed object) to depress the
rewind button “R”. (Do not use an awl, needle, or other very sharp
instrument).
^3^ If desired, the camera can be set to leave the film leader outside the
film cartridge after rewind is completed (p. 47).
20