Edition 05/2021 – CC200 D – Notice technique – page 10
SACOME, Document CONFIDENTIEL, Ne peut être reproduit ni communiqué sans notre accord préalable.
7.2. HOT WATER DOSE PROGRAMMING
«Hot water» key
Methodology:
One programming dose is available:
• Press key n°5 (MENU) from the 1st group during 5 seconds.
• Display shows « Press dose selection within 30s ».
• Push hot water key to start the flow, and push again when the water volume is correct.
• You can use hot water key after the message «Press dose selection within 30s» disappears.
To Next Page
