Edition 05/2021 – CC200 D – Notice technique – page 12
SACOME, Document CONFIDENTIEL, Ne peut être reproduit ni communiqué sans notre accord préalable.
8.2. AUTOMATIC CLEANNING OF COFFEE GROUP
The cleaning of coffee group is made group by group, preferably at the end of service, before the
machine is stopped or put in "ECO" mode, using this specific function managed by the machine.
The procedure for cleaning coffee groups is as follows:
• Remove the filter-holder from the group and clean the seal with the supplied brush.
• Insert blind filter (provided with the machine) in the filter-holder.
• Put a detergent tablet (CONTI brand code: 466662) in the blind filter, and engage the filter-holder in the
group.
• Keep pressing key “P5 Gr1”, then press the key “P1 Gr1”.
• The cleaning process starts automatically, with somes ON/OFF cycles. The purpose is to disolve the
tablet, and release the cleaning agent on the coffee group circuit and on the coffee valve.
• the display indicate
• When the cleaning cycle is finished, and the group is available again.
• Repeat this operating mode on each group.
The cleaning cycle can be interrupted, pushing any key of the concerned group. But, you will lost the
following steps, and will compromise the cleaning efficiency.
It is possible to perform an automatic washing cycle for each group independently
8.3. RESETTING DATA
If necessary, it is possible to re-configure the machine with data by default.
The procedure is as follows:
• Turn off the power supply of the machine.
• Keep pressing simultaneously the keys “P1 Gr1” + “P3 Gr1”+”P5 Gr1”
• Turn the machine on.
• the display indicate
To return to normal operation, turn off and on the machine.
To Next Page
Loading...
