Conti MC ULTIMA - Page 31

Edition 05/2021 - MC ULTIMA- Technical documentation - page 31
SACOME, CONFIDENTIAL Document, it is forbidden to duplicate or communicate this document without previous authorization.
10.6.4 Further installation parameters adjustment
 Press on the bookmark dots at the bottom of the screen to change page:
 The display shows :
 Press on the desired digit to highlight it and change the value.
 The display shows the logos + et – .
 Press on + et – to adjust the value and to validate
10.6.4.1 Boiler power:
 This step is to define the maximum power supply available for the machine.
 Example: 2  Max 22 Amp. (see chapter power management)
 Programmable value: from 1 to 6
10.6.4.2 Boiler filling mode:
 This step allows the machine to fill the tanker with or without the pump.
 In case of “kit solo” system the machine needs to be adjusted with a filling up with pump.
 Programmable value : with or without pump
10.6.4.3 Maintenance cycle:
 This menu allows the machine to display a message for a service after a programmed number of
cycle (example 20000 cycles)
 Keep the button pressed to accelerate the scrolling during the adjustment
 Programmable value : 0 to 990000 cycles
 If the value = 0: function disabled.
10.6.4.4 Water filter:
 This parameter defines a number of liters of water consumed from which the machine displays an
invitation to change the filter cartridge (depending on the hardness of the water and the capacity of
the water treatment)
 Keep the button pressed to accelerate the scrolling during the adjustment
 Programmable value : 0 à 99999 liters
 If the value = 0: function disabled.