EasyManua.ls Logo

Continental Fireplaces CX36NTR-1 - User Manual

Continental Fireplaces CX36NTR-1
82 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
INSTALLER: LEAVE THIS MANUAL WITH THE APPLIANCE.
CONSUMER: RETAIN THIS MANUAL FOR FUTURE REFERENCE.
NEVER LEAVE CHILDREN OR OTHER AT RISK INDIVIDUALS ALONE WITH THE APPLIANCE.
INSTALLATION AND
OPERATING INSTRUCTIONS
CERTIFIED TO CANADIAN AND AMERICAN NATIONAL STANDARDS: CSA 2.22 AND ANSI Z21.50, FOR VENTED DECORATIVE GAS APPLIANCES.
EN
FR
PG
73
FOR INDOOR USE ONLY
SAFETY INFORMATION
! WARNING
If the information in these instructions
are not followed exactly, a fire or
explosion may result causing property
damage, personal injury or loss of life.
- Do not store or use gasoline or other
flammable vapors and liquids in the vicinity of
this or any other appliance.
- WHAT TO DO IF YOU SMELL GAS:
• Do not try to light any appliance.
• Do not touch any electrical switch; do not
use any phone in your building.
• Immediately call your gas supplier from a
neighbour‟s phone. Follow the gas
supplier‟s instructions.
• If you cannot reach your gas supplier, call the
fire department.
- Installation and service must be performed by a
qualified installer, service agency or the supplier.
This appliance may be installed in an
aftermarket, permanently located, manufactured
home (USA only) or mobile home, where not
prohibited by local codes.
This appliance is only for use with the type of
gas indicated on the rating plate. This appliance
is not convertible for use with other gases,
unless a certified kit is used.
CB36NTR / CB36NTRE &
CX36NTR-1 / GCX36NTRE-1
NATURAL GAS MODEL
CB36PTR / CB36PTRE &
CX36PTR-1 / CX36PTRE-1
PROPANE GAS MODEL
SAFETY
BARRIER
CB36
ILLUSTRATED
! DANGER
HOT GLASS WILL CAUSE
BURNS.
DO NOT TOUCH GLASS UNTIL
COOLED.
NEVER ALLOW CHILDREN TO
TOUCH GLASS.
A barrier designed to reduce the risk of burns from
the hot viewing glass is provided with this appliance
and shall be installed for the protection of children
and other at-risk individuals.
Wolf Steel Ltd., 24 Napoleon Rd., Barrie, ON, L4M 0G8 Canada / 103 Miller Drive,
Crittenden, Kentucky, USA, 41030 Phone 1 (866) 820-8686 www.continentalfi
replaces.com ask@continentalfi re.on.ca
W415-1679 / D / 03.09.18

Table of Contents

Other manuals for Continental Fireplaces CX36NTR-1

Questions and Answers

  • J
    James TaylorNov 27, 2025
    How to fix a pilot light that will not light on my Continental Fireplaces CX36NTR-1?
    • D
      Daniel HallNov 27, 2025
      If the pilot light won't ignite on your Continental Fireplaces Indoor Fireplace, there are several things to check: * First, verify that the sensor wire and igniter wire are connected to the correct terminals on the module (not reversed). * Ensure there are no loose connections, electrical shorts, or grounding issues in the wiring. * Check the igniter spark gap, it should be 1/8” (3.2mm). * Confirm the transformer is installed and plugged into the module, with a voltage between 6.2 and 7.0 volts A.C. when the switch is ON. * If using a battery backup, check the batteries. * Remove and reinstall the wiring harness, verifying continuity of each wire. * Troubleshoot with a simple ON/OFF switch to rule out improper switch wiring. * Ensure the valve and pilot assemblies are pro...
  • C
    Carlos GalvanAug 25, 2025
    Why is the pilot sparking but not lighting on my Continental Fireplaces Indoor Fireplace?
    • R
      robertleeAug 25, 2025
      If your Continental Fireplaces Indoor Fireplace pilot sparks but won't light, start by verifying that the incoming gas line ball valve is 'open'. If you are using propane, check if you are out of propane gas and fill the tank if necessary. The pilot supply line may contain air, so repeat the ignition process several times or purge the pilot supply line. Ensure correct polarity of wiring of thermocouple (if equipped). You can also reset program: hold reset button on receiver and wait for 2 beeps. Release after second beep. Press small flame button on remote within 20 seconds, you will hear an additional beep (this signals a successful reset).
  • N
    Nathan SmithAug 25, 2025
    Why won't my Continental Fireplaces CX36NTR-1 Indoor Fireplace perform any functions?
    • J
      Jason HooverAug 26, 2025
      If your Continental Fireplaces Indoor Fireplace won’t perform any functions, check the breaker to ensure it’s in the 'on' position. If equipped, verify that the 3 position switch on the receiver is in the remote position (middle). Also, check the transmitter’s battery power and orientation.
  • J
    Jose SmithAug 26, 2025
    Why is carbon depositing on surfaces of my Continental Fireplaces CX36NTR-1?
    • M
      Michelle KirkAug 26, 2025
      If carbon is being deposited on the glass, logs, rocks, media, or combustion chamber surfaces of your Continental Fireplaces Indoor Fireplace, it could be due to an improperly adjusted or blocked air shutter. Return the air shutter to the specified opening, and ensure the air shutter opening is free of lint or other obstructions.
  • D
    Daniel NelsonAug 27, 2025
    What to do if pilot sparks but gas supply will not light on my Continental Fireplaces CX36NTR-1 Indoor Fireplace?
    • A
      amy52Aug 27, 2025
      If the pilot sparks but the gas supply won't light in your Continental Fireplaces Indoor Fireplace, first, ensure the incoming gas line ball valve is open. Then, verify that the inlet pressure is within acceptable limits, not exceeding 13” W.C. (32.3mb). Also, make sure the air shutter opening is free of any obstructions like lint. If you are using propane, ensure that the tank is full.
  • B
    baileymarcusSep 15, 2025
    Why does the main burner go out but pilot stays on in my Continental Fireplaces CX36NTR-1?
    • S
      Sarah ShawSep 15, 2025
      If the main burner goes out but the pilot stays on in your Continental Fireplaces Indoor Fireplace, it could be due to the pilot flame not being large enough or not engulfing the thermopile. Turn up the pilot flame. Alternatively, the thermopile might be shorting; clean the thermopile connection to the valve and reconnect it.
  • K
    Kevin HernandezSep 13, 2025
    Why are the flames so aggressive on my Continental Fireplaces CX36NTR-1 Indoor Fireplace?
    • S
      Shannon MunozSep 13, 2025
      If the flames on your Continental Fireplaces Indoor Fireplace are very aggressive, check if the door is ajar and tighten the door clamps if applicable. If the venting action is too great, restrict the vent exit with a restrictor plate.
  • B
    Brian MooreSep 14, 2025
    How to make the pilot flame larger on my Continental Fireplaces Indoor Fireplace?
    • A
      asanchezSep 14, 2025
      If the pilot flame is not large enough on your Continental Fireplaces Indoor Fireplace, turn up the pilot flame.
  • S
    Sarah HolderSep 6, 2025
    What to do if the pilot lights but the main burner won't light on my Continental Fireplaces CX36NTR-1 Indoor Fireplace?
    • E
      emily71Sep 6, 2025
      If the pilot lights but the main burner won't turn on in your Continental Fireplaces Indoor Fireplace, check for shorts or loose connections in the sensor rod. Ensure all connections are tight and not grounding out to any metal. Also, ensure the wire harness is firmly connected to the module.
  • J
    Jessica CrawfordSep 3, 2025
    What causes white/grey film to form on my Continental Fireplaces CX36NTR-1?
    • L
      leegabrielSep 3, 2025
      If a white or grey film forms on the glass, logs, or combustion chamber surfaces of your Continental Fireplaces Indoor Fireplace, this is likely sulphur from the fuel being deposited. Clean the glass, following the 'CARE OF GLASS' section, and ensure you do not clean the glass when it is hot.

Summary

1.0 Installation Overview

2.0 Introduction

2.1 Dimensions for CB36; CX36-1

Provides critical physical dimensions for appliance installation.

2.2 General Instructions

Offers essential safety guidelines and operational advice for safe appliance use.

2.4 Rating Plate Information

Details crucial model, gas type, and certification information on the appliance's rating plate.

3.0 Venting

3.1 Venting Lengths and Components

Specifies required vent pipe lengths, types, and approved components for safe installation.

3.2 Typical Vent Installation

Illustrates standard procedures for top and rear vent pipe installation.

3.4 Minimum Air Terminal Location Clearances

Defines critical clearances for vent termination locations to ensure safe operation.

4.0 Installation

4.1 Wall and Ceiling Protection

Outlines methods for protecting walls and ceilings from heat and ensuring proper clearances.

4.3 Using Rigid Vent Components

Provides instructions for installing rigid vent pipe systems.

4.6 Gas Installation

Covers essential safety and procedural steps for connecting the gas supply.

5.0 Framing

5.1 Framing for CB36; CX36-1

Explains framing requirements and considerations for building an enclosure for the appliance.

5.2 Minimum Enclosure Clearances

Specifies required clearances around the appliance enclosure for safe operation.

5.6 Minimum Mantel Clearances

Details required clearances between the appliance and any mantel.

6.0 Finishing

6.1 Safety Barrier & Door Removal; Installation

Instructions for removing and installing the safety barrier and glass door.

6.3 CB36; CX36-1 Log Placement

Guides proper placement of logs and embers for optimal flame appearance.

7.0 Wiring Diagram

7.2 CB36 Electronic Wiring Diagram

Provides a visual guide for connecting the electrical components of the CB36 model.

7.3 CX36-1 Electronic Wiring Diagram

Illustrates the electrical connections for the CX36-1 model.

8.0 Operation (electronic)

9.0 Operation (millivolt)

10.0 Adjustment

10.1 Pilot Burner Adjustment

Details how to adjust the pilot burner for proper flame size and performance.

10.2 Venturi Adjustment

Explains how to adjust the air shutter for optimal flame characteristics.

11.0 Maintenance

11.1 Annual Maintenance

Outlines essential annual checks and cleaning procedures for the appliance.

11.3 Care of Glass

Provides instructions for cleaning and maintaining the appliance's glass.

12.0 Replacements

12.1 CB36 Overview

Exploded view and parts list for the CB36 model.

12.4 CX36-1 Overview

Exploded view and parts list for the CX36-1 model.

15.0 Troubleshooting (electronic)

16.0 Troubleshooting (millivolt)

17.0 Warranty

Continental Fireplaces CX36NTR-1 Specifications

General IconGeneral
BrandContinental Fireplaces
ModelCX36NTR-1
CategoryIndoor Fireplace
LanguageEnglish

Related product manuals