Continental Fireplaces CX70NT User Manual

EN
FR
PG
65
W415-1540 / 08.04.15
INSTALLER: LEAVE THIS MANUAL WITH THE APPLIANCE.
CONSUMER: RETAIN THIS MANUAL FOR FUTURE REFERENCE.
NEVER LEAVE CHILDREN OR OTHER AT RISK INDIVIDUALS ALONE WITH THE APPLIANCE.
INSTALLATION AND
OPERATING INSTRUCTIONS
Wolf Steel Ltd., 24 Napoleon Rd., Barrie, ON, L4M 0G8 Canada /
103 Miller Drive, Crittenden, Kentucky, USA, 41030
Phone (705)721-1212 • Fax (705)722-6031 • www.continentalfi replaces.com • ask@continentalfi re.on.ca
1.24C
$10.00
CERTIFIED FOR CANADA AND UNITED STATES USING ANSI/CSA METHODS.
SAFETY INFORMATION
!
WARNING
- Do not store or use gasoline or other fl ammable
vapors and liquids in the vicinity of this or any
other appliance.
- WHAT TO DO IF YOU SMELL GAS:
• Do not try to light any appliance.
• Do not touch any electrical switch; do not use
any phone in your building.
• Immediately call your gas supplier from a
neighbour’s phone. Follow the gas supplier’s
instructions.
• If you cannot reach your gas supplier, call the
fi re department.
- Installation and service must be performed by a
qualifi ed installer, service agency or the supplier.
If the information in these instructions
are not followed exactly, a fi re or
explosion may result causing property
damage, personal injury or loss of life.
HOT GLASS WILL CAUSE
BURNS.
DO NOT TOUCH GLASS UNTIL
COOLED.
NEVER ALLOW CHILDREN TO
TOUCH GLASS.
!
DANGER
A barrier designed to reduce the risk of burns from
the hot viewing glass is provided with this appliance
and shall be installed for the protection of children
and other at-risk individuals.
This appliance may be installed in an aftermarket,
permanently located, manufactured home (USA
only) or mobile home, where not prohibited by
local codes.
This appliance is only for use with the type of gas
indicated on the rating plate. This appliance is
not convertible for use with other gases, unless a
certifi ed kit is used.
Decorative Product: Not for use as a heating appliance.
BARRIER
CX70 ILLUSTRATED
SAFETY BARRIER
CONFORMS TO AMERICAN NATIONAL STANDARDS: ANSI Z21.50-2012, CERTIFIED TO CANADIAN CSA 2.22-2012 FOR VENTED GAS FIREPLACES.
CX70PT & CX70PTE
PROPANE GAS MODEL
CX70NT & CX70NTE
NATURAL GAS MODEL

Continental Fireplaces CX70NT Specifications

General

Fuel Type	Natural Gas
Efficiency	Up to 70%
Ignition System	Electronic Ignition
Vent Type	Direct Vent
BTU	24, 000

Summary

SAFETY INFORMATION

DANGER

1.0 INSTALLATION OVERVIEW

2.0 INTRODUCTION

2.1 CX70 DIMENSIONS

2.2 GENERAL INSTRUCTIONS

2.4 RATING PLATE INFORMATION

3.0 VENTING

3.1 VENTING LENGTHS AND COMPONENTS FOR DIRECT VENT INSTALLATIONS

Specifies vent lengths, components, and installation requirements for direct vent systems.

3.2 TYPICAL VENT INSTALLATION

3.3 SPECIAL VENT INSTALLATIONS

3.3.1 PERISCOPE TERMINATION

Specific instructions for installing a periscope termination for venting configurations.

3.4 MINIMUM AIR TERMINAL LOCATION CLEARANCES

3.8 TOP EXIT HORIZONTAL TERMINATION

3.9 TOP EXIT VERTICAL TERMINATION

4.0 INSTALLATION

4.1 WALL AND CEILING PROTECTION

Guidelines for protecting walls and ceilings around vent pipes and systems using firestops.

4.3 USING RIGID VENT COMPONENTS

4.3.1 HORIZONTAL AIR TERMINAL INSTALLATION

Instructions for installing rigid vent components through a horizontal air terminal.

4.5 GAS INSTALLATION

4.6 OPTIONAL WALL SWITCH (MILLIVOLT ONLY)

Information on installing optional remote wall switches or thermostats for millivolt systems.

5.0 FRAMING

5.1 MINIMUM FRAMING DIMENSIONS

Specifies the minimum dimensions required for appliance framing, including clearances.

5.2 MINIMUM ENCLOSURE CLEARANCES

5.4 MINIMUM COMBUSTIBLE MANTEL CLEARANCES

6.0 FINISHING

6.3 SAFETY SCREEN / DOOR REMOVAL AND INSTALLATION

6.4 LOG PLACEMENT

6.7 WIRING DIAGRAM (ELECTRONIC)

7.0 OPERATION

7.1 CX70NT/CX70NTE & CX70PT/CX70PTE (MILLIVOLT)

Operating instructions for millivolt models, including pilot lighting and burner control.

7.2 CX70NTE & CX70PTE (ELECTRONIC)

Operating instructions for electronic models, including remote and automatic pilot lighting.

8.0 ADJUSTMENT

8.1 PILOT BURNER ADJUSTMENT

Procedures for adjusting the pilot burner flame size for optimal performance and safety.

9.0 MAINTENANCE

9.1 FLAME CHARACTERISTICS

Guidance on visually checking and identifying proper flame characteristics for operation.

9.2 ANNUAL MAINTENANCE

10.0 REPLACEMENTS

10.1 NIGHT LIGHT REPLACEMENT

Steps for replacing the night light bulb and lens in the appliance.

10.2 DOOR GLASS REPLACEMENT

10.3 BLOWER REPLACEMENT

11.0 CX70 OVERVIEW

12.0 CX70NT/PT MILLIVOLT VALVE TRAIN ASSEMBLY

13.0 CX70NTE/PTE ELECTRONIC VALVE TRAIN ASSEMBLY

14.0 CX70 ACCESSORIES

15.0 TROUBLESHOOTING (ELECTRONIC)

Pilot will not light

Troubleshooting steps for issues where the pilot fails to light, checking wiring and igniter.

Pilot sparks but will not light

Steps to diagnose and fix issues with pilot sparking but not igniting, checking transformer and connections.

16.0 TROUBLESHOOTING (MILLIVOLT)

Main burner goes out; pilot stays on

Solutions for when the main burner shuts off but the pilot remains lit, checking flame and thermopile.

Main burner goes out; pilot goes out

Steps to resolve issues where both pilot and main burner extinguish, checking gas supply and venting.