Control Techniques UNIDRIVE M701 User Manual

www.controltechniques.com16
Smartcard
Parameter storage / cloning
The Smartcard is a memory device that can be used to
back-up parameter sets and PLC programs, and copy
them from one drive to another.
Auto
Save
Auto
Save
Boot
Pr 0.30 = rEAD +
Drive reads all parameters
from the Smartcard.
Pr 0.30 = Prog +
Programs all drive parameters
to the Smartcard.
Note: overwrites only data
already in block 1.
Pr 0.30 = AutO +
Drive automatically writes
to the Smartard when a
parameter save is
performed.
Pr 0.30 = boot +
Drive boots from the Smartcard on
power-up and automatically writes to the
Smartcard when a parameter save is
performed.

Control Techniques UNIDRIVE M701 Specifications

General

Brand	Control Techniques
Model	UNIDRIVE M701
Category	Servo Drives
Language	English