Control Techniques UNIDRIVE M701 - User Manual

WARNING! This document is a guide only. It does not provide safety
information. Incorrect installation or operation of the drive could result
in injury or equipment damage. Refer to the Unidrive M700/M701/M702
Control User Guide for essential safety information.
UNIDRIVE M700
UNIDRIVE M701
UNIDRIVE M702
High Performance
AC/Servo Drives
Quick Startup, Operation
and Maintenance Guide

Summary

Control Wiring - Unidrive M700;M701

Control Wiring - Unidrive M702

Control Connections Overview

Details terminal assignments and connections for control signals on Unidrive M702.

Keypad & Display Operations

Keypad and Display Interface

Navigating Menus and Parameters

Editing and Modifying Drive Parameters

Saving Drive Parameter Values

Resetting Drive to USA Defaults

Drive Display Messages

Alarm Indications

Trip Code Troubleshooting

Details trip codes and troubleshooting tips for common drive faults.

Induction Motor Setup - Open Loop

Open Loop Configuration

Configuration parameters for setting up induction motors in open-loop mode.

Induction Motor Setup - Closed Loop

Permanent Magnet Motor Setup - Closed Loop

Closed Loop Configuration

Configuration parameters for setting up closed-loop permanent magnet motors.

Servo Motor Setup

Servo Motor Configuration Parameters

Configuration parameters for setting up servo motors in various modes.

Autotune Procedure

Procedure for performing an autotune for servo motors to optimize performance.

PC Tools and Connectivity

Unidrive M Connect Tool

Smartcard Parameter Management

Parameter Storage and Cloning

Control Techniques UNIDRIVE M701 Specifications