Item Part Number Type Description
1 TCPS Power Supply Replacement power supply for ChlorMaker & SmarterSpa
1 CM-Electrode Electrode ChlorMaker replacement electrode
2 Insta-Test-4 Test Kit
Insta-Test 4 Spa Test Strips, Chlorine, pH, Hardness &
Alkalinity
3 Insta-Test-Salt Test Kit Insta-Test Salt Pool and Spa Test Strips Sodium Chloride
4 CM-CELL Cell Body Replacement cell body, electrode is a separate item.
5 CMIL-KIT Kits In-Line Conversion Kit for ChlorMaker
6 CELL-HIDE Kits
Includes 2 cable grips to conceal the electrode in the spa
filter compartment
7 PS-HIDE Kits
Includes a 2 foot pigtail and 1 cable grip to connect the
control box to the spa pack
8 104PS2 Kits Saddle clamp install zinc sacrificial anode for 2” pipe
Ÿ Just doesn’t keep up:
§ Remove organic material such as leaves and clean the filter
Make sure the cell is at the deepest point in the spa and in a VERTICAL ORIENTATION!
§ Remove the phosphates: Phosphates are food for algae and consume chlorine. The ChlorMaker makes
chlorine slowly and removing the phosphates will help lower the spas chlorine consumption demand
§ Shock the water: You can use either a chlorine based shock or chlorine free
Consistently High Chlorine
Ÿ Power level too high: Lower the power level
Ÿ Lower the salt level by adding some water
The ChlorMaker is off, No Lights
Ÿ Check if in the standby part of the cycle, watch and see if the GREEN lights flash every 10 seconds
Ÿ The GFCI circuit breaker has tripped. Verify that there is input VAC.
Ÿ The power supply has been damaged. The rain cover didn’t prevent moisture from the power supply, was
subjected to freezing weather or the cord has been cut.
Replacement Parts & Accessories
The titanium plates of any saltwater chlorine generator will eventually wear out and need replacing. Visit
www.controlomatic.com and select Shop which will take you to our store.
NOTE: Installing the ChlorMaker inline may void the spas warranty and UL safety certification as you will be
adding to the existing equipment of the spa. We can provide the conversion kit CMSCIL-KIT or you can find
the required parts at your local hardware store. If you install it inline we recommend spas with a 24 hour
continuously running pump that has 3/4” tubing.
To Next Page
Loading...
Need help?
General
