ControlOMatic ChlorMaker Operating Instructions

ChlorMaker Installation
Prepare the SPA
Drain and clean the spa, refill and add salt. Allow
the water to get to over 95°F and balance the
water.
Installation Steps
1. Install a protected electrical outlet, if not
already available near, the spa for the Power
Supply
2. Mount the control Box
3. Drape the ChlorMaker cell over the side of the
spa, ensure it is hanging vertically
4. Turn the ChlorMaker on
5. Set the power level
Power Supply
The power supply supports 100 to 240 VAC with an output voltage of 5.5
VDC. The supply cord from the Power Supply to the ChlorMaker control
box is 15 feet. Installing any equipment inside the spa equipment
compartment may void the spa warranty or void the safety certification of
the spa and is not recommended.
110 VAC Electrical Outlet
Locate a GFCI protected outlet near the spa. WARNING: A 110 VAC
GFCI or GFI protected outlet is required. A weather protective cover is
required to house the power supply at the power source connection.
Weather protective covers are available at most local hardware stores. If
an outlet needs to be installed, have a licensed electrician add a 110 VAC
GFI protected outlet.
220 VAC Electrical Outlet
The power supply plug style is for 110 VAC. Have a licensed electrician
install a 220 VAC GFI protected connection near the spa that will accept
a 110 VAC style plug. The outlet may need to be a minimum distance
from the spa and the local electrical codes should be checked.
Power Supply Connector
Remove the tie straps from the ChlorMaker power supply cable and route the cable to the outlet, do not plug in
yet. The cable should already be attached to the power supply, the connector has 2 metal pins, one is round
and the other is rectangular and can only go in one way, reversing the connection will damage the ChlorMaker.
The ChlorMaker includes 2 cable clips, use one (3/16” with a #6 x 1/2” screw) to attach the cable to a solid
surface if necessary.
Cold Weather Operation
The power supply is not designed for temperatures below 32ºF or 0ºC. If this can’t be avoided store the power
supply in a warm location when the temperature is low or install the power supply in the spa equipment area
where there is some protection.

ControlOMatic ChlorMaker Specifications

General

Brand	ControlOMatic
Model	ChlorMaker
Category	Water Filtration Systems
Language	English