MiniWarden Manual • 530-205-4520 • 4
8 WARNING – Disconnect all power to MiniWarden prior to any
service including the main AC power. Never apply power when
MiniWarden service door is unlocked or in the open position. Only
qualified and licensed technicians should perform any service or
repair.
9 WARNING – Do not install load bearing leads and/or sensor cables
longer than 3 meters.
10 WARNING – Always mount MiniWarden in safe and dry area. Never
mount MiniWarden above any other electrical equipment.
11 WARNING – Install MiniWarden in a location that is not accessible to
the public.
12 WARNING – Pool and Spa Chemical Safety
12.1 Never mix sodium hypochlorite and muratic acid!
12.2 When mixing acid and water, always add acid to the
water, never add water to the acid.
13 CAUTION – TEST THE GROUND FAULT CIRCUIT INTERRUPTER
BEFORE EACH USE OF THE POOL/SPA
14 CAUTION – CONNECT ONLY TO A CIRCUIT PROTECTED BY A
CLASS A GROUND FAULT CIRCUIT INTERRUPTER
15 Do not dispose in trash. Please visit www.controlomatic.com
for recycling information.
ATTENTION: TOUJOURS VÉRIFIER L’EFFICACITÉ DU
DISJONCTEUR DIFFÉRENTIEL AVANT D’UTILISER LE BAIN
ATTENTION: LIRE LA NOTICE TECHNIQUE
AVERTISSEMENT: DÉCONNECTER DU CIRCUIT D’ALIMENTATION
ÉLECTRIQUE AVANT L’ENTRETIEN
ATTENTION: CONNECTER UNIQUEMENT À UN CIRCUIT PROTÉGÉ
PAR UN DISJONCTEUR DIFFÉRENTIEL DE CLASSE A
IMPORTANT WARNING AND SAFETY INSTRUCTIONS
To Next Page
Loading...
Need help?
General
