Controls MVP-L3100 - Page 13

CONTROLS, INCORPORATED
C O N T R O L S Y S T E M S & S O L U T I O N S
13
(4)
Engine Safety Configuration
Sender Check Bypass
Fuel Level Check
Low Fuel Pre Alarm
Low Fuel Alarm
Fuel Alarm Delay
Oil Pressure Check
Low Oil Pressure Pre Alarm
Low Oil Pressure Alarm
Oil Pressure Alarm Delay
Temperature Check
Low Temperature Pre Alarm
Low Temperature Alarm
High Temperature Pre Alarm
High Temperature Alarm
Temperature Alarm Delay
Battery Voltage Check
Low Battery Pre Alarm
High Battery Pre Alarm
Over Speed Alarm
Over Speed Set Selection
Over Speed Alarm Delay
(5)
Module Configuration
Display Units (English, Metric)
Hour meter Source (Engine ECU, Internal)
Battery Source (J1939, Internal)
Battery Volt Trim
(6)
CAN Configuration
Source Address (Default = 0) Others available
Speed Transmit (Default = On)
Temperature Transmit (Default = On)
Oil Pressure Transmit (Default = On)
Fuel Level Transmit (Default = On)
Voltage Transmit (Default = On)
Hours Transmit (Default = On)
Fault Transmit (Default = All)