Convaid Cruiser 14

To Next Page

To Previous Page

888-Convaid (266-8243)

Cruiser 14

INSTRUCTIONS

Standard Footplate Assy Kit - Left

1. Pull out metal pin and remove the existing footplate extension tube. Item 2

2. Using a 5/32" allen wrench, remove both bolts from the housing bracket on the frame

and remove existing footplate assembly components.

3. If needed, install tube connector Item 4 into the front leg by hammering or pressing

it into the front leg tube.

4. Slide the loop portion of the detent pin with webbing assembly over the

front x-brace tube.

5. Align footrest extension housing Item 3 with the front leg.

6. Apply some thread locker Item 7 on the thread portion of the screws Item 5 .

7. Using a 5/32" allen wrench, attach the footrest extension housing onto the front leg

using the screws provided Item 5 .

8. Reattach the footplate adjustment tube and secure it with the

detent pin Item 6 .

Convaid Cruiser 14 - Page 19