888-Convaid (266-8243)
3
Cruiser 14
INSTRUCTIONS
One Piece Height Adjustable Push Handle
1. Using a phillips screwdriver and a 3/8” wrench, remove the screw attaching the
handle tube assembly from the Cruiser Back Tubes.
2. Slide existing handle assembly off.
3. Slide new handle assembly onto the back tube. Item 1
4. Align the holes on the plastic pivot joint of the handle tube assembly with the holes
of the back tubes.
5. Insert new screw Item 3 into pivot joint.
6. Attach the nut Item 2 and tighten using a phillips screwdriver and a 3/8” wrench.
To Next Page
Loading...
