Convaid Cruiser 14 - Page 9

888-Convaid (266-8243)
5
Cruiser 14
INSTRUCTIONS
One Piece Height Adjustable Push Handle with
Attendant Handbrake
1. Remove Cable from Lever by pulling the cable away from the lever & routing the inner
cable off the level
2. Using a phillips screwdriver and a 3/8” wrench, remove the screw attaching the
handle tube assembly from the Cruiser Back Tubes.
3. Slide existing handle assembly off.
4. Slide new handle assembly onto the back tube. Item 1
5. Align the holes on the plastic pivot joint of the handle tube assembly with the holes of
the back tubes.
6. Insert new screw Item 3 into pivot joint.
7. Attach the nut Item 2 and tighten using a phillips screwdriver and a 3/8” wrench.
Attached cable onto the lever on the new handle.