4.
1 specifications
- Your new PICCOLO is a fan heater partially enclosed.
- This heater is equipped with 2 fan forced heat levels : 750 W regulated with the electronic
thermostat and 1500 W fast heat on demand.
- Minimum obstruction and designed to heat your room quietly, consistant heat, it is
a perfect heater for your bathroom or other intermittently-used rooms.
- Your PICCOLO can be used with the optional CONVECTAIR Programmer Module
(pilot wire) allowing scheduled temperature set-backs in periods of prolonged absence
providing the same comfort and more savings.
READ CAREFULLY :
These instructions are essential to install and use your new PICCOLO safely.
2 recoMMended set-up
- Your heater must be installed in accordance with national and local codes and
CONVECTAIR recommends an installation by a qualied electrician.
- Your heater must be installed so that the control panel is out of reach from anyone in
the bath-tub or in the shower. Do not install over a bath-tub or spa.
- Do not install the heater behind a door, furniture or others obstacles, or in front of an air
exhaust vent. Keep combustible materials such as curtains, away from the heater.
- Your heater is equipped with a heating element that may reach high temperatures. Do
not install or operate in the presence of gasoline, paint solvents or other ammable
products.
- Maintain the minimum required clearances (height from oor, distances from side walls
or furniture, drapes, etc...)(Fig. 2).
To Next Page
Loading...
