10
PASSWORD
For added security, it is possible to set a password/4 digit pin number
which needs to be entred to start the ebike system.
In the ‘Password’ menu, press ‘M’ to turn the password function on/off.
When the password is turned on, an old password will be requested, the
default is ‘0000’. Use ‘M’ to select each digit, and up/down to change
the value.
Then enter a new password/pin number (twice to conrm).
Press Mode to conrm the modication and go to the next setting.
the next time the bike is turned on, the password will be requested.
ASSIST SPEED-LIMIT SETTING
BATTERY
INFO
RESET
AUTO OFF
When the running speed is faster than the speed limit setting, the
controller will cut off the motor power. The speed limit default setting is
25Km/h. Press +/- to select the desired value. 99Km/h is unlimited.
Press ‘M’ to conrm the modication and go to the next setting.
The Battery menu gives a summary of the % and current Voltage of the
battery and number of charge cycles.
The Info menu gives a summary of the display information. serial
number, Firmware and Hardware versions.
This will perform a factory reset and all cutom settings will revert back
to their default setting
It is possible to adjust the system time-out which shuts down the
system after inactivity.
In ‘AutoOff’ mode, scroll up/down and select the desired Auto Off delay
between 1, 2, 3, 5, 8, 10 minutes. Default is 5 Minutes.
To Next Page
Loading...