6 Moving and setting up the appliance
ConvoVent 4 / ConvoVent 4+ 55
4.
Take the lighting-unit supply cable through the two feedthroughs
on the left below the condensation hood.
5.
Plug the lighting-unit supply cable into the connector on the
condensation hood.
6.
Insert the lighting unit in the condensation hood first on the left
then on the right.
7.
Push the tab on the alignment plate up against the outer wall of
the condensation hood.
8.
Slide the lighting unit gently towards the hood front until it en-
gages.
9.
Press on the rear section of the mounting plate to push the
lighting unit upwards.
Caution:
Take care not to trap the supply cable.
10.
Fix the lighting unit to the condensation hood using the 2
mounting-plate bolts removed earlier; first hand-tighten the fixing
bolts then tighten using an open-ended wrench.
To Next Page
Loading...