To Next PageTo Next PageWhy do cooking smells linger when using my Cooke & Lewis Ventilation Hood?
If cooking smells linger when using your Cooke & Lewis Ventilation Hood, it may be because the carbon filter is not fitted in recirculation mode or is full of grease. Fit a carbon filter or replace the carbon filter.
Why is my Cooke & Lewis CLCGS90 Ventilation Hood suction performance reduced?
Reduced suction performance in your Cooke & Lewis Ventilation Hood can occur for several reasons. The speed may be too low, so select a higher speed. The aluminum filters might be dirty, so clean them. The top vent could be obstructed, so clear any obstruction. If fitted, the optional vent kit might be twisted, so ensure it is fitted according to the manufacturer’s instructions. Also, the installation may not comply with the manufacturer's instructions; the vent hose should be the correct diameter throughout with no reductions or restrictions.
What to do if my Cooke & Lewis CLCGS90 is vibrating excessively?
Excessive vibration in your Cooke & Lewis Ventilation Hood can be due to several factors. The appliance might not be installed properly on the brackets, in which case you should take down the appliance and check it is properly fixed. Alternatively, the fan blade could be damaged, so switch off the appliance and have it repaired by qualified service personnel only. It may also be caused by the fan motor not being fixed tightly.
What to do if the light is on but the fan does not work on my Cooke & Lewis CLCGS90?
If the light is on but the fan does not work on your Cooke & Lewis Ventilation Hood, it could be due to the fan blade being jammed or the motor being damaged.
What to do if both the light and motor do not work on my Cooke & Lewis CLCGS90?
If both the light and motor do not work on your Cooke & Lewis Ventilation Hood, the light bulb may have blown, so replace it with a bulb of the correct rating. Also, the power connection may be loose, so check the power supply.
General| Brand | Cooke & Lewis |
|---|---|
| Model | CLCGS90 |
| Width | 90 cm |
| Number of Fan Speeds | 3 |
| Lighting | LED |
| Color | Stainless Steel |
| Filter Type | Aluminium |
Read safety instructions carefully before installation and use to avoid misuse and hazards. Contact customer services if damaged.
Warning about electric shock/fire risk during cleaning and correct fixings for appliance installation and support.
Installation by a competent person, voltage check against rating plate, and compliance with wiring diagrams are essential.
Connect directly to mains via omnipolar circuit breaker with 3mm contact separation. Ensure correct electrical connection.
Appliance is Class II (no earth). Connect using 2-core cable (Brown=Live, Blue=Neutral). Use 3 Amp fuse.
Details supply voltage, power consumption (fan, luminary, total), protection class, light bulb type, and ILCOS code.
Provides data for EU energy labelling: Annual Energy Consumption, Fluid Dynamic Efficiency, and Energy Efficiency Index.
Details measured air flow rate, pressure, maximum air flow, air flow in normal use, and lighting efficiency.
Tips for reducing environmental impact include efficient ventilation, regular cleaning, and switching off light/hood when not in use.
Appliance cannot be dismantled by user. Dispose of responsibly according to local waste disposal regulations.
24 months guarantee against manufacturing defects. Covers parts and labour, excludes wear and tear, misuse, etc.
Contact customer services for service calls. Provides UK/Eire phone numbers and email addresses.
Information on recycling waste electrical products (WEEE) and proper disposal methods.
