13
In more detail...
GB IE
Care and maintenance
Appliance cleanliness
> The appliance should be cleaned after use.
> Wipe the inner and outer surface of the appliance and its accessories
with wet cloth.
> Any liquid overowing from the pan must always be removed with
a cloth.
> The surface of the hob may be easily cleaned as follows:
Cleaning of enamel parts:
To maintain the features of the enamel parts, wash frequently with soapy
water.
Never use abrasive powders. Avoid leaving acid or alkaline substances on
the enamel parts (vinegar, lemon juice, salt, tomato juice, etc.) and washing
the enamel parts while they are still warm.
Cleaning of stainless steel parts:
Wash these parts with soapy water and then dry them with a soft cloth.
The shine is maintained by regularly cleaning them with special products
normally commercially available. Never use abrasive powders.
Cleaning of burner ame dividers:
Given that they are not xed, the ame dividers can be cleaned by
simply removing them and washing them with soapy water. After drying
them well and checking that the holes are not blocked, put them back
into their correct position.
Warning
Always switch off the electricity supply before
performing maintenance work. In the event of a fault,
contact customer services.
Caution
• Use soapy water and a cloth for cleaning. Never
use abrasive powders.
• Avoid banging pots and pans down on the hob.
• Do not leave any empty pan on the heating zone.
FUSE
OFF
To Next Page
Loading...
Need help?
General
