Issue 4 05/08/2021 6
PREPARATION FOR USE
Before using the espresso maker for the first time.
It is important to thoroughly clean the appliance before first
use.
1. Place the espresso maker on a stable, flat, heat resistant
surface and away from surfaces that may be damaged by
steam.
2. Remove all tape used for product transit.
3. Lift the lid of the water tank and using the integrated
handle, remove the water tank and fill with water. Do not
fill past the ‘max’ mark on the tank. Refit the water tank
and close the lid.
4. Fit the filter into the filter holder
5. Offer the filter holder to the brewing head and align the
handle with the ‘unlocked’ padlock symbol on the front
face of the appliance (fig. 3).
6. Move the handle firmly to the right (as shown in the
diagram) until it is aligned with the ‘locked’ padlock
symbol (fig. 4 & 5).
Fig. 3 Fig. 4 Fig. 5
7. Place a small jug or similar onto the drip tray directly
underneath the nozzles of the filter holder.
8. Ensure that the steam knob is aligned with the ‘0’.
9. Check that all buttons are in their raised (off) position.
10. Fully unwind the cable, plug in and switch on. For safety
do not allow the cable to dangle over the edge of units.
To Next Page
Loading...
Need help?
General
