Cookworks MY-CS6007WP - Fitting the Condensate Cup; Removing and Fitting the Lid; To Fit the Lid

ISSUE-1 2/8/2017 7
Fitting the condensate cup
Removing and fitting the lid
To remove the lid (figs. 2) - hold the lid by the handle and turn the lid
anticlockwise until the alignment mark () on the rim of the
pressure cooker housing is aligned with the ‘unlocked’ padlock
symbol on the lid. Lift off the lid.
To fit the lid (figs. 3)- Position the lid above the pressure cooker and
align the ‘unlocked’ padlock symbol on the lid with the alignment
mark () on the rim of the pressure cooker housing. Turn the lid
clockwise until the ‘locked’ padlock symbol is aligned with the
alignment mark ().
Slide the condensate
cup into position at the
reverse of the pressure
cooker as shown (figs. 1)
Figs. 1
Figs. 2
Figs. 3